GTB Propane

[yellowjacket]

Anyone have a pic of the guage/dash cluster or dash panel set up for GTB propane. Repair manual only shows dash/guage set up for diesel and gas. Propane is different. I'm restoring a propane and I don't think what is on it is correct it looks home made. Thanks

 

[ken in texas]

My UB special factory propane has same guages as gasoline models. propane tank has either a valve that will show fuel level ,when opened and turned,propane will spew out .Or guage on side of tank to show level .Or that has been my experence.

 

[Curt Cooke]

Yes but a "standard" tractor like a G or a UTS, if it's an LP has a different dash configuration. It's a similarly shaped bucket that's bolted to the steering support. Sorry, I don't have a up close picture.

 

[yellowjacket]

that picture helps out. Mine currently has a square box mounted to the left side of the steering support and the "teardrop" shaped smaller box with the amp guage, switch, push button and dash light is mounted in the center of the box with 2 holes made in the bottom for the oil pressure and temp. So in your picture, this was factory set up?

 

[Curt Cooke]

Yes, the pic however is a UTS Special. My GB is the same. You have a GTB and that may be different, I'm not sure.

 

[Ill John]

My 49 GTB/LP has a similiar gauge setup as in the picture, have to go look to tell what gauge is in what position. My 50 UTS/LP has the ammeter in the panel but the other 2 gauges are independently mounted.

 

[moline]

My GTC had the dash you are describing from the factory(sqare box).But it also had the clamshell fenders.Could you have a dash from a GTC mounted on your GTB?