jon f mn

Well-known Member
Came across this on fb and thought it was pretty ingenious.


cvphoto64214.jpg


cvphoto64215.jpg


cvphoto64216.jpg


cvphoto64217.jpg


cvphoto64218.jpg


cvphoto64219.jpg


cvphoto64220.jpg
 
Hey, that's a good idea, several years ago a coworker had an actual tool with the 4 fingers for that, but if I recall correctly, it did not work very well, the fingers bent.
 
same principal as the tap removers. be ok if the tap is not stuck to tight and gets you out of a bind.
 
It does make you wonder what these folks were doing to break that tap. I assume they were only chasing out the treads, but who knows they may have been cutting new ones due to stripped out old threads. Anyways, its only cast material, some cutting oil and finness shouldn't have broke it. Or I suppose they may have not drilled out the hole to the proper size. That, I do not miss about my old job- we primarily used stainless steel for everything... tapping stainless is a whole new ball game, especially when it's a small size like 4-40 into a blind hole.
 
Tapping or chasing threads in exhaust parts can be very difficult, I do not know the metallurgical reason, but the parts seem to be hardened by repetitive heat cycles.
 
Your correct you are not mistaken and I reckon those other fellas never broke a tap, I on the other hand have broken numerous taps from 2-56 up to 3/8-16 with ease I think I remember a 1/2-13 once but not with ease that took some doing LOL, And I am sure for many different reasons. I have even broken End Mills, may have even broken a drill bit or 2. A lot happens in 50 yrs as a toolmaker/ Machinist / Machine assembly Technician and service Tech./ Mechanical Engineer. BTW tap extractors came in real handy many times and now that I am retired I still have a large assortment of tap extractors just in case.
 
well IMHO to break that big a tap off it needs lube and more forward and back it more then likely galled up the metal and locked the tap up
 
I own factory built sets of tap extractors, that there may work part of the time, the ones I have do work Very well I have saved a number of things for friends as well as myself once or twice with them, I bought mine off the Snap On trucks
 
Walton Tap Extractors are the ones I have used, same principal as what jon did. Also always look at a tap closely to check for sharpness If dull there is a greater chance for breakage.
 
I wasn't running the lathe doing the tapping, but one bar out of 3 semi-trailer loads of 4" 4130 aircraft quality cold drawn steel bars broke a 2"-4-1/2 threads per in tap off, turned bar around, drilled and tapped other end and broke a second tap. The shop managed to break up the remains of the tap and got it threaded deep enough without breaking a 3rd tap. The other end they welded a plug in the hole and ground it smooth. Then the tapped around 150 more bars with that 3rd tap.

Hammer pins for automobile shredders, think of a hammermill feed grinder 8 ft wide by 7 feet in diameter. And we made bigger ones too. 8 ft diameter by 9 ft wide.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top