Help ID finish mower

[SlowCredit]

Picked up an old finish mower. 5'. Deck is solid, but hubs-spindles are no good. Hinged flaps on sides and rear. 3 spindles and 2 pulleys. Gearbox seems solid. Only has wheels on back.

Anyone have an idea what this is? Or better yet, where I can find a 3 bolt spindle (5.25 center to center on holes)

Mower blades have 1.375 center hole which seems very uncommon. . .

Not having any luck finding spindles or the 1-off blade.

Thanks in advance for any info or ideas!

Slow

 

[SlowCredit]

Pics. . .

 

[J Hamilton]

You should be able to put new bearings in
the spindles as long as the shaft and
housings are good

 

[SlowCredit]

It's definitely plan b - would like to be able to ID so I can see if I can find the blades - the ones I have are in rough shape and are just about worn out.

I might be able to find someone with a lathe and get the standoff turned down to 1" from 1-3/8. Or I guess I could put blades with a 1" hole on the drill press and widen holes to 1-3/8. . . Both of those are putting even more work into a pretty poor starting place.

Thanks for your thoughts

 

[J Hamilton]

I've been trying to find blades with those dimensions, but I haven't found anything like that and I've not seen a mower like it either