Help replacing brakes

Ian Poland

New User
Can anyone help with the proper procedure for replacing the brake shoes on a 1956 Ford 650 tractor. Thank you to all of you that helped me identify my tractor...I finally found the model # under a couple coats of paint!!
 
Hello Ian;

To remove the brake shoes;

1. Raise the tractor and install jack stands under the rear axle housing

2.Remove the rear wheels

3. Remoove the brake shoe attaching screws or spring nuts from each drum and remove the brake drums. (you may need to loosen the shoes with the brake adjuster accessed from the back of the brake backing plate)

4. Disconnect the brake shoe return springs and the retracting spring from the brake shoes.

5. Remove the two anchor pin retainer clips and drive the pins out of the backing plate.

6.Remove the anchor pin collar, brake shoe hold down spring, cups and pin from each shoe.

7. Expand the brake shoes at the upper end and remove them from the backing plate as an assembly.

8. Separate the shoes from the adjusting screw assembly and spring.

Note: the brake assemblies are the same for each wheel except for the brake shoe return springs. The right brake has two return springs; the left only has one.

Also, you may find it difficult to remove the anchor pins as they are probably rusted in. Use some PB Blaster or similar penetratiing oil and soak them, then try driving them from the back out. Sometimes heat is required. Hope this helps.

As a suggestion, I would purchase a Ford Shop Manual and a Master Parts Catalog. The shop manual tells you how and the Parts catalog has great diagrams.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top