Chuck (CA)
Well-known Member
I cracked the rear end housing on my New Holland last year... bad... hyd oil leaking through a 6 inch crack. A local welder did not want to attempt it without removing ALL residual oil and being able to weld from both inside and outside... not feasible. I was turned on to Lock N Stitch and after talking to them (great people), I bought the pins, drill bits, tap, video, etc. for 300.00 plus change. I was kind of intimidated by it all, but my son, Joe, who's a maintenance mechanic, said he would do it. Long story short, the repair is done, almost invisible, and no leaks! The photo shows it partially repaired.
I haven't used the 3 point yet, but I'm confident it will hold.
FWIW, Be sure to remove the swinging draw bar before using the rotary mower. :-(
I haven't used the 3 point yet, but I'm confident it will hold.
FWIW, Be sure to remove the swinging draw bar before using the rotary mower. :-(