2colorgreen
Member
- Location
- Mid Michigan
Who makes lightweight hubs for Oliver 88
Gary Mitchell
Well-known Member
I bought 9 hole center plates from "Hey Wheel", steel tubing that fit my axles from the local steel guy, had the local shop slit short pieces of the tubing and weld keystock into that. After having the correct size holes turned in the center plates I took it all home and welded it up with added gussets and hammered them onto the axles. After getting them where I wanted them I drilled a 3/8 hole in each tube, into the axle, welded on a nut, and set a bolt into the axle hole to keep it in place. I bolted the wheels on. gm
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy