Hydraulic issues on Jubilee

Shaun M

New User
Can someone please tell me what the hell Im missing....
Hydraulics on Tractors worked fine one minute the just quit. So I took apart the hyd. pump, replaced vanes and rotor, took off lift cover, replaced ram cylinder ring and gasket, flushed oil. flushed lines, still nothing, took off lift cover again, checked the check valve. all looks good, ajusted constant draft setting to spec. still nothing...im lost. what else am I missing? Need to help as we are about to get 18 inches of snow tonight and need to plow. any and all comments are much appreciated

Thanks
Shaun
 
I assume you've tried bleeding the pump?
Have you put a pressure guage on it to see what the pump is putting out?
Dunno the Jubes well but there must be a test port on it - under the front of the seat maybe?
A pipe plug you can screw a guage into?
Deciphering hyd problems without a pressure guage is like deciphering electrical problems without a multimeter.
Without one you're just guessing.
 
Take a look at the attached
a28655.jpg
 
yep.. there is a pipe plug ont he puny top cover option plate, and there is an inverted head plug lower down that you can also get pressure at.

soundguy
 
6 will get you 10 that all that happened was you lost prime on the pump. I have a problem like that all winter. It happens so often that I put a petcock in the top plug on the pump so all I have to do is crack it open and within a couple of seconds it's up and running. I have replaced the gaskets and everything but still it does it. Cant find a leak where its sucking air so it must be internally in the pump or along the shaft but its not leaking oil out so I since I know how to quickly fix it I just live with it. Remember Occam's Razor "the simplest explanation is more likely the correct one" LarryT
 
Shaun, The best thing I put on my Jubilee was a 3000 psi pressure guage on the pump. Until I got all my problems worked out, I had a fitting attached to a clear plastic hose to bleed my pump. I returned the oil to the sump. Had to remove my hose after I got it blead. Someone on this sight make a pipe and valve system to bleed his hyd so all he had to do is open the valve to bleed.

I learned that after you bleed your pump, the oil should remain in the pump while it's not running. If the oil leaks back into the sump, you have a problem. My problem was a broken spring inside the piston pump.

Also learned that my pump only make enough pressure to register on the guage while you are lifting something heavy.

Another trick I learned is that an electric wench is very helpful for when you remove the lift cover by yourself.

If you watch this sight, you will find that many people have hyd issues. Welcome to the club. I noticed after removing my lift cover 3 times, there is a lot of crap that gets into the hyd oil from the lift arms and the spring on the upper lift point.

LOL
Gorge
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top