hydraulic maual

[duramax]

anyone have or know where to print off a PDF file of the hydraulic system and rebuilding or putting in new seals and gaskets along with adjustments is what im looking for. i have a 1943 2N and the 3 point shakes when going up added more oil to full line shaking stopped but has no power picking up as in i can stand on 3 point arms and it just doesnt move at all until i jump off of it then it goes straight up. anyone have any input on this situation?

 

[TheOldHokie]

(quoted from post at 15:28:54 11/13/10) anyone have or know where to print off a PDF file of the hydraulic system and rebuilding or putting in new seals and gaskets along with adjustments is what im looking for. i have a 1943 2N and the 3 point shakes when going up added more oil to full line shaking stopped but has no power picking up as in i can stand on 3 point arms and it just doesnt move at all until i jump off of it then it goes straight up. anyone have any input on this situation?

The hydraulics are fully contained in the rear section - remove the side inspection cover(s) and look for leaks while attempting to lift a load on the 3pt. Drips from above indicate a leaking lift cylinder and/or top cover gasket - far cheaper than a pump rebuild.

TOH

 

[duramax]

is that where the dipstick is? sorry im very new to this tractor and really dont know anything but what others have been telling me on here as in Dell, Bruce and so many others and i thank everyone for all the help, just need it broke down barney style so they say. lol

 

[lha]

Adding more oil is only going to add other problems,as you have seen.To determine the correct level,remove the bottom bolt on the plate with the dipstick.Mine was the same as on the dipstick,but many are not the same.With a good light,you can see a lot going on in there.---lha

 

[souNdguy]

here's it in plain terms.

BUY A I&T FO-4 SERVICE MANUAL

the new ones have parts diagrams and part numbers.

( i'd reccomend an owners manual AND a parts manual too )

soundguy

 

[duramax]

yes i did that dell told me to watch out for wrong dipsticks and pulled 6 o'clock bolt out and the dipstick was right but poured really really slow took a few hrs i poured so slow and then waited for it to drain pour more then wait. thanks for the advise there but Dell did get to me the other day to watch out for it thanks again though..