Hydraulic problems

jackw

New User
About 18-20 months ago I posted a problem I was having with my model 640 tractor. I was using a 5' rotary mower and after raising and lowering it several times I noticed oil coming out of the shift lever. I was told at the time that there are 2 hydraulic lines that run through the transmission housing to the lift cylinder that can rust out or crack. The remedy would be to sleeve the lines or split the tractor. I am finally ready to fix the problem and I didn't print any of the information, so if anyone could send that info again I would appreciate it.
 
Hi jackw, welcome to the Ford forum.
It doesn't look like you posted the question as a member so searching the boards for your past posts may prove difficult.
I have read several posts from people that have done just what you are looking at. You may find info by searching the forum for "640 hydraulic line sleeve". Short of that you may have to pose the question again if someone doesn't answer you this round.
 
Welcome to the forum Jack. You are right about the two tubes. The tubes carry oil from the sump to the engine mounted pump and returns the oil under pressure to the hydraulic system. Oil coming out of the shifter is the classic symptom of a leaking pressure tube (the smaller of the two).

You have two options to fix this. Have a replacement pressure tube made by a machine shop (replacement tubes are not available). The old tube can be pulled out and the new tube pressed in. This can be done without a split.

Option 2 is to sleeve the existing tube with a piece of 3/8" hydraulic tubing. This tube is epoxied in place. This method is about 50% successful. Cleaning the old tube and coating both the old tube and new tube with epoxy is critical to success. This can be done without a split but is much easier if you have access to both sides of the transmission.

A good search of the archives will yield lots of information. If you need more help post back.
 
The tubes are available from a source in south Georgia. They are $85.00 each, IIRC. I will try to find the contact info and post soon.
 
(quoted from post at 23:55:43 04/30/14) The tubes are available from a source in south Georgia. They are $85.00 each, IIRC. I will try to find the contact info and post soon.

If those are the tubes that others have posted about, then I don't think they are correct. Someone on here bought them and they are straight tubes with the same outside diameter along they entire length, and they really need to be stepped, with different diameters at different points along the length. Someone else posted a drawing with measurements of what the exact diameter needs to be at each spot along the length. If you search the archives you should be able to find that information.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top