IH 350 Utility Remote Hydraulics

[alek9997]

Hi there

This is probably a rather basic question but can someone tell me what # parts I need for my International 350 Utility to operate a remote cylinder such as on an implement? Right now all I have is the original "default" setup; the rear valve which raises and lowers the Fast Hitch and no front valve, only a cover. See the picture attached.

Thanks

 

[Janicholson]

The cover on the rear valve is the same as the cover in front of it on the side of the reservoir. purchase IH valves like the rear one, and stack them onto the the mounting surface where the front plate is located. Put the shown cover on the outside of the new valves. Jim

 

[sunsettractor]

Hello Jim,
On my 300 Utility, there is a tube, or manifold that connects the front and rear valves, the outer covers have a threaded port for this. Would that tube and the different covers be needed for the 350, or is that setup just used on the 300 ? Please know that I am not questioning your reply, I was just curious as to the purpose of that tube connecting the two valves together, such as the one on my 300 Utility.
By the way, your recommendation for fixing the sloppy hydraulic valve handles way back on my 300 worked great, very tight now, Thanks...Tom

300U Sloppy Hydraulic Lever Fix ? 2 27 17

 

[Janicholson]

Could be, but I am not where the tractor is, and don't remember the line! Jim