IH wrench

[jbp]

Bought some stuff at a sale and an IH wrench was among the items. It is a box end on both ends, 1 1/4 by 1 , number 350370-R1. It is probably only about 12 or 14 inches long. Anyone know what the wrench was used for? Thanks, Joe

 

[Allan in NE]

Sounds like a H/M tractor wrench.

Allan

 

[armand tatro]

11/4" would be for rear wheel axel clamps. 1" should be for bolts mounting implements to tractor or for older front wheels with 3 mounting bolts maby. Always seek a second opinion. LOL. Armand

 

[Todd in NC]

That wrench was commonly called a plow wrench, around here. It was used on the Cubs and Super A's etc. to install and remove the draw bar or cultivators. It also worked on International plows and field cultivators. Hope this helps, Todd.

 

[Hoover913]

That part number matches up with the wrench listed in the TC-52 parts manual (page 171) which is for the Farmall/McCormick 100, 130 and 140 series tractors. It probably is listed for other models as well.

 

[Badger08]

Are you keeping it or is it for sale?