International 2424

[robertohk40]

Hello All I'm new to this site. Need help finding the hydraulic filter on International 2424 tractor? also what type or number is the air filter cross refernce too?

 

[M-MAN]

If it has a filter it's in the round cannister below the dash. There's a suction filter on the big line going into the rear hydraulic section. Just slide the hose off, remove the 5/16 bolt and pull it out. Wash it good and put it back. There's also a high pressure filter behind the 1 inch bolt in the front of the hydraulic section just left of center. Clean and reinstall.

Baldwin # PA1644 for a gas engine. No idea about a diesel.

 

[robertohk40]

If it has a filter it's in the round cannister below the dash. There's a suction filter on the big line going into the rear hydraulic section. Just slide the hose off, remove the 5/16 bolt and pull it out. Wash it good and put it back. There's also a high pressure filter behind the 1 inch bolt in the front of the hydraulic section just left of center. Clean and reinstall.

Baldwin # PA1644 for a gas engine. No idea about a diesel.

M-Man thanks a ton. I saw that canister and was wondering what it was for, its rather small. Any idea what the baldwin number is on the hydro filter?

 

[Absent Minded Farmer]

M-Man thanks a ton. I saw that canister and was wondering what it was for, its rather small. Any idea what the baldwin number is on the hydro filter?

Here's a link to a parts catalog on the 2424 diesel. If yours a gasser, look for "Online Parts" at the top of the page, click on CaseIH & enter the model number to change it. That will at least get you the original numbers to cross to whatever brand you like.

2424D Link....

Mike

 

[M-MAN]

WIX # 51666 for the hydraulic filter. Should have mentioned if oem style it can be cleaned also.

 

[robertohk40]

WIX # 51666 for the hydraulic filter. Should have mentioned if oem style it can be cleaned also.

Thx! Your helping me out a ton been very hard to find info on this old thing. It is a gas motor. On another note, can you tell me if hydro/trans oil is good for its tranmission and the PTO hydro? Also, what motor oil would you recommend for 90 degree to 10 below temps? I saw someone on youtube using 5w-10 in a 424 was wondering if sae 30 or 10w30 or 40 would be better?

 

[Janicholson]

Thx! Your helping me out a ton been very hard to find info on this old thing. It is a gas motor. On another note, can you tell me if hydro/trans oil is good for its tranmission and the PTO hydro? Also, what motor oil would you recommend for 90 degree to 10 below temps? I saw someone on youtube using 5w-10 in a 424 was wondering if sae 30 or 10w30 or 40 would be better?

15-40 diesel grade oil is a good compromise and recommended often on this forum. Jim

 

[M-MAN]

I use this for transmission and hydraulics. RK house brand.

 

[robertohk40]

I use this for transmission and hydraulics. RK house brand.

Thx!

 

[Tim in New York]

I almost exclusively use my 2424 during cool/cold weather months. So for quite a few years I have used 10w/30 oil. No issues doing that at all. Its probably cheaper than the 10W40 options. I can get a gallon on-sale at NAPA for about $18 if I time it right.