International 464 3 point hitch problem

firerott24

New User
Hi everyone. First time in thsi forum. I have an international 464 that was converted from a 2400A. They took the front loader and backhoe off and put an international 3 point hitch on it. I can't figure out why my lower levers go all the way to the ground. And it's hard to adjust and keep setting while bushogging. I think the 3 point hitch needs adjusting but the manual doesn't say how to. I'm not new to tractors just this Frankenstein (what my grandson named it) is frustrating me. And I cannot for the life of me find the front brackets to attach a weight bracket to it. I appreciate any help you guys can give me!
 
If the lift arms go to the ground the bell cranks are probably just installed on the rockshaft in the wrong position. I don't know about a 464, but on my IHs you just take out the bolt from the center of the bell crank, pull the bell crank off and move it however many splines it takes to get the lower arm at the proper height. Then do the same with the other side. An owner's manual should have the specs in it.
 
Thank you I have the service manual but it only says how to take it off and fix things.
If the lift arms go to the ground the bell cranks are probably just installed on the rockshaft in the wrong position. I don't know about a 464, but on my IHs you just take out the bolt from the center of the bell crank, pull the bell crank off and move it however many splines it takes to get the lower arm at the proper height. Then do the same with the other side. An owner's manual should have the specs in it.
Do you happen to know of any diagrams to show me where this is at? My shop manual doesn't have it.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top