Is this something Red Green would do?

Geo-TH,In

Well-known Member

cvphoto132814.jpg
 
It may look funny, but the law says a replacement needs to cover the same area and be as strong as the original. That looks like it might be red oak. If it is, you would fare better hitting the original Ford bumper than that. The more elite use planed dimension timbers, nicely finished with clear polyurethane.
 
lol.... A teacher at our school had a wooden bumper on the front of an old Rambler back in the 70's. It, at least, was a milled piece thus removing some of the colour from his neck....haha
 
My dad had a 67 International with a 4x12 pusher bumper on the front.

When my car was down it was my back up. Drove it to school a few times, it was a real chick magnet!
 
He he worked more with Cadillac or station wagons cheaper.
I havent seen all the episodes ,just an impression
 
When I was a kid during the 60s, every Tow Truck had a big thick plank mounted on the front. Lots of cars were manual shift, and if your car wouldnt start on a cold morning, the tow truck could push you down the street till it did start. I also remember the tow trucks having pipes bolted on the back of the planks vertically, about 2 foot high. These pipes were there to wrap booster cables on to. Most tow trucks had 20-30 foot of cable, so they could pull up behind a car that was in a driveway, and have enough cable length to reach from the truck to the front of the car. During cold spells in the winter tow trucks could be busy most of the day just getting cars started. Now with electronic ignition and fuel injection, cars start so much better.
 
I have a friend with a pickup & 460 engine that liked to run warm. He made a bumper with a big pipe & had it full of coolant. Took care of the heating problem. Not sure how he had it hooked up to circulate.
 
The one truck I remember had a cut open rear tractor tire covering the plank bumper for softer push contact.
 
For years there was an old sedan around town with a 2x8 belted across as a back bumper. I think you need a bumper and so there it was, all legal.

Paul
 
I don't remember any starting problims like that, 48 Olds, 49 Buick, 49 Cadilac, 50 Buick. 55 Desota, 59 Merc, 60 Rambler, 63 Rambler, 67 Rambler, 49 Chevy truck, 50 International truck. That 48 Buick was my first car and I have driven all listed. Problems running started with 77 ANC with electronic ignitation. Had to cary spare control box at all times in both cars.
 
If there is a law it is not enforsed as you see so many vehicals on road with no bumper on front andeven trucks without a bumper now. Our 49 Chevy truck came from factory with no rear bumper.
 
(quoted from post at 08:45:49 08/10/22) When I was a kid during the 60s, every Tow Truck had a big thick plank mounted on the front. Lots of cars were manual shift, and if your car wouldnt start on a cold morning, the tow truck could push you down the street till it did start.

Many of them also had an old rear tractor tire flattened out and bolted to that plank.
 

Went to college in Michigan in the late 80s. Lots of salt use...

I'd occasionally see one of the midsize GM cars from late 70s early 80s that were prone to the rear bumper rusting out from the inside having been replaced with a wood plank of some sort.

Left alone, those bumpers rusted out where the frame mounts were and would literally fall off the car.
 
I just know you see so many street rods running without any bumpers, This includs both front and rear. just saw one in parking lot yesterday. Forget what place. Not untill the 80's did you actually see very many pickups with a rear bumper.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top