ISO conversion

[ET]

Is there a kit to convert the remote couplers on a 3010 or 4010 to ISO? The kit for the 20 series and newer does not work.

 

[cowboy4996]

There is nothing available from Deere. I have not seen anything aftermarket, although there could be something out there that I'm not aware of.

 

[larryanderson]

Probably stuck with using the plug in type.Imagine how much money would have been saved if JD and IH would have stuck with pioneer couplers.I think IH changed with 66 series and JD with the 10 series.We have a container full of them.

 

[Tx Jim]

ISO is listed in PC 691 for 4010 but I didn't see kit #.

 

[Tx Jim]

Have you considered just mounting some Pioneer breakaway couplers utilizing hoses in lieu of steel tubes?

 

[tomstractorsandtoys]

The best thing to do is buy a rear outlet off a 20 series tractor and rebuild it. The 20 series were a big improvement over the 10 series in how easy the hoses plug and unplug. The only issue is if you are doing the left outlet as on a 10 series as a 20 series will not bolt up without drilling and tapping new holes in the housing. Tom

 

[ET]

I was thinking about putting a 20 series coupler block on. Will the right side bolt up to the rockshaft housing? What fittings are you using to reduce to the 3010 size hydraulic lines?