JD 2010 loader hookup

[grwrench]

hello, deere guys,, a friend has a 2010 tractor, he wants to put a front loader on,, how can he have a live hookup with separate control valve without using the breakaway coupler ???

 

[wore out]

hello, deere guys,, a friend has a 2010 tractor, he wants to put a front loader on,, how can he have a live hookup with separate control valve without using the breakaway coupler ???

There was a "power beyond plate" the replaced the original cover at the top of the hydraulic valve(s), but I don't immediately see it in the 2010 PC. Perhaps it's shown a an applicable loader parts catalog?

 

[Tx Jim]

My advice to your friend is find a better tractor with loader already installed. 2010 hyd system leaves a lot to be desired.

 

[JIM MN]

On that tractor you will have to plug into the rear breakaway coupler then to a control valve.

 

[Tx Jim]

On that tractor you will have to plug into the rear breakaway coupler then to a control valve.

What if tractor has no scv/breakaway coupler? Then one must follow parts photo I posted earlier.

 

[buickanddeere]

Just install the loader valves in series with the HP line from the pump . It is an open center system .

As previously stated, the 2010 is never going to make a decent loader tractor . Unless you have an engineering degree, a complete machine shop and deep pockets .

 

[rockcreek4630]

hello, deere guys,, a friend has a 2010 tractor, he wants to put a front loader on,, how can he have a live hookup with separate control valve without using the breakaway coupler ???

With that tractors very questionable hyd system your best to use a pto pump.

 

[jwal10]

I had a 2010 loader tractor back in the day. Not a bad loader, it was a JD, don't remember the model. It clamped to the rear axle and used the remote to run the loader. But, it had a trip bucket. Better than the old Farmall H loader. I could get the 2010 under the hog shed. I would use the remote and a 1 lever, 2 way stick, on a small (light) loader. Otherwise do like I did get a 2020 JD. Next was a 2030 JD, now that was an excellent loader tractor, had a quick change loader....James

 

[grwrench]

There was a "power beyond plate" the replaced the original cover at the top of the hydraulic valve(s), but I don't immediately see it in the 2010 PC. Perhaps it's shown a an applicable loader parts catalog?

hello,, i was rusty on the hookup on this tractor,, but in the back of my mind i think i remember a couple holes in the RH sheet metal below the gearshifter, and the hookup from plumbing there..

 

[grwrench]

My advice to your friend is find a better tractor with loader already installed. 2010 hyd system leaves a lot to be desired.

hello,, TX Jim,, i AGREE 110% on that, but he already has the tractor,, he is coming back to get my advice on HOW to hookup the loader. he found a JD 143 loader .

 

[Tx Jim]

grwrench
JD 143 loader wasn't designed to fit a 2010 & very possibly could have a closed center hyd control valve. I think mounting brackets will require modification to fit a 2010. Shown in following link is the only thing I can locate in 143 parts catalog that applies to open-center control valve which this type was designed for 3 cyl tractor models 820, 830 & 2040. https://partscatalog.deere.com/jdrc/sidebyside/equipment/3208/referrer/navigation/pgId/2604718