JD 325 PTO control circuit board

[Dave in SV]

On an earlier post, I asked about wiring diagrams for a 345 to help a neighbor/friend. I just found out it's a 325, built in the mid '90's.

Clutch won't energize. I bypassed the circuit board and the clutch works... so I am assuming the problem is on the board (I see what looks like a burned trace). The only number I could find on the PC board is P.T.3.1-0. Does anyone recognize this part number? Or does anyone know where I can find the correct part number and locate a replacement PC board?

 

[j meyer]

if your certain you got a bad circuit board, then call or go to your local John Deere dealership and ask the parts guy to look up the part number and buy the new board from him.

 

[Dave in SV]

Yeah, you're right... I just thought that if I had the part number, maybe I would get lucky and find a schematic diagram for it and fix it. I hate to think what mother Deere will price a new PC board for!

 

[j meyer]

Those boards arent as pricey as you may think. Sure, it may run 100 bucks or so, but that isnt that much money these days.

 

[Dave in SV]

Local JD shop says that the part number is AM132500, and it runs $87 plus tax. Not as bad as I thought!