jd 60 head

[dan bucks]

Hello everyone. I have a 56 60 and would like to get some head work done. Looking o make a high compression head any help on were to get this type of work in the pa area. Thanks for any help Dan

 

[jd50A]

Don't know where you are located in Pa. but Triple "G" Service in Alden NY, just outside of Buffalo does very good work. Head milling, Valves, boreing and high compression pistons.
Call 888-720-0830 I had work done there very good.

 

[jerry03755]

Try Carquest machine shop Phoenixville,Pa. Ask for Dave.

 

[2-banger]

bob at triple g doesnt do any of his own work d&h performace in bativa ny does most of his work guys name is jim good guy..ive got a 60 we pull.. doing hd work isnt going to make it high compression..my 60 has 225 psi with a lot of hd work..we do our own hds..i had josh blackburn in mi lengthen my rods and ratio my rockers,,i also run a lp manifold set..pretty hard to beat my 60 on most days if i set it up right..lol go to [ulling forum and get ahold of josh

 

[buickanddeere]

Can't mill a 60 head into a high compression head and expect to keep head gaskets.
Time for some high compression pistons, blending the rough edges inside the ports and a 5 angle valve job. A reground cam and followers too.

 

[dan bucks]

thank for all the help. i am in the learning stages of this stuff. so thank for the help and any points you are willing to give. thanks agian

 

[dan bucks]

jerry03755 do you happen to have the phone number for carquest machine shop