JD D Gear Shift

arsones

New User
Trying to get some questions answered about the John Deere D: I know some tractors are better than others at shifting gears without clutch, and without bringing the tractor to a stop. What's the process for shifting gears on the D?

And on another note, when did JD start producing tractors with a "fast" and "slow" setting? I believe the D had 3 forward speeds so I'm guessing it just had a single gear shift lever. Thanks!
 
If you practice at getting the clutch speed to match your travel speed you may be able to slide it in but then you might grind or worse yet knock a tooth off so best not to try it.
 
you need a complete stop . you will not shift any D or other 2 cyl while moving. i take it your not familiar with the D. it was built for 30
years. they have a clutch brake on them also. they are a slow shifting tractor. compared to the W6 ih those you could shift on the fly if
your good.
 
(quoted from post at 20:48:59 08/11/21) you need a complete stop . you will not shift any D or other 2 cyl while moving. i take it your not familiar with the D. it was built for 30
years. they have a clutch brake on them also. they are a slow shifting tractor. compared to the W6 ih those you could shift on the fly if
your good.

"you need a complete stop . you will not shift any D or other 2 cyl while moving"

That's COMPLETE "horsepucky" rusty, with a little practice and finnesse it's easy to do.
 
Well, sorta...in my case, I can shift on the go, but it took a lot of
practice....would help to have 3 hands, one for the throttle lever, one for the
shift lever and one for the clutch lever...and get all hands coordinated!

Ben
 
The Styled D had an optional drive sprocket set to give it a higher road speed I believe.
Personally, I wouldn't want to take a chance on damaging the transmission just to shift gears while moving.
The D will start in High gear pulling just about any 'normal load anyway...
 
A true 2 cylinder guy knows how to shift on the fly.... :). It takes a little practice, but is easily done once you know what you are doing. The ones with the High/Low shift were particularly easy. It is a bit like driving a B Model Mack, though... you need more hands!
 
yes ,... but a mack is a totally different animal, you dont need a clutch. i have driven the old mac's.so have you shifted these D'S on the fly? it just makes no sense , pick the gear u want and go. one out of 3 usually work good.
 
Not much need on a D... but want to start a load on a road with a 70 or similar? That's when you use the shift on the go method. The trick is to not let the pulley (or trans top shaft) stop spinning completely. Disengage clutch, but don't stop the pulley.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top