JD Gator Overheating

2underage

Well-known Member
I think I am on the right forum as I use my JD 6 wheel gator for a tractor sometimes. I have a problem with it overheating and I believe the fan is not running. Could it be a heat sensor or a relay somewhere in the cooling system and how do I fix it? I am resistant to taking it to a John Deere dealer as they are far way and expensive. Looking for a do it yourself repair or replace cure. Thanks to all for any advice. Happy farming.
 
I had a 6X4 gator several years back. I remember a removable screen in front of the radiator. This screen served as a filter for the radiator. Might be worth checking and cleaning it if needed.....
 
There is no relay in the cooling fan circuit, just the fan and the temp switch on the bottom of the radiator. Is the radiator getting hot or just the engine? If they get low on coolant the water pump can airlock and not circulate coolant to the radiator.
 
Thanks to all who replied to my post. My problem is that the fan does not run. I believe I will need to troubleshoot the system to determine if it is the fan or the heat sensor. Any suggestions will be appreciated. Happy farming.
 
first off it might not be quite full of engine coolant. it says how to get the engine block and rad FULL of coolant in the operators manual, I believe you have to take a bracket off the rad hose filler and lift it up in the air to make sure its right full. check this first, then try to bypass the temp sensor that is stuck in the fins of the radiator. with a jumper wire, if your fan comes on constantly that lets you know your fan is working, and it might be a faulty sensor. number one reason is like others stated that there is air or not enough fluid in the system but best to make sure your fan and sensor work anyways. good luck.
 
2underage, I just had the same problem with my 6X4 Kawasaki Gas model and it turned out to be the coolant temperature sensor that runs through the radiator fins and hooks to the fan motor (part number 13 on the John Deere Gator 6X4 parts site). I have a Curtis Cab on ours and it was really a challenge to work it with the cab on but it can be done--just have to lift the cab in order to get the engine cover out between the frame of the gator and the cab. You have to remove the seats, the engine cover and you will then have access to the radiator and fan. Before you start taking things apart, unhook the two leads that go to the temp sensor and jump the two leads off the fan motor to see if the fan works. If the fan works, its your temp sensor. You will also see a blue wire at the bottom of the fan which is the hot wire--if fan doesn't work, check to see if the blue wire is hot. It is a REAL challenge to get the sensor out. I managed to take the top two torx bolts out of the fan housing and lean it back far enough to get the sensor out. Believe it or not, the sensor slides through the fins of the radiator so be careful putting the new one in not to force it and puncture a tube in the radiator. I put a 2x4 across where the driver and passenger seats rest and drove it to ensure the sensor worked before I put it back together--saves skinned knuckles!! Part Number is AM118587 and costs around $110 at the local JD Dealer!!! If the fan works with the new sensor, button it back up and you should be good to hook!! Hope that helps! E-mail is open if needed!! Good Luck!!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top