John Deere 3010LP will not start

[ILB]

I posted last week regarding it would not start and did the different thinks suggested. Solenoid does click. If I take the plug off the bottom of the solenoid and open vapor valve I do not get any vapor. If I open other valve I do get LP, but no dirt out of the bottom. I continued to try and start and the line below the convertor and the carb do frost up on the outside. I do have enough LP in the tank. Any further help would be appreciated. Thanks in advance to all who help.

 

[Tx Jim]

How long since fuel filter has been changed???

 

[chuck from neb]

Is the radiator full of antifreeze if it's only half a gallon low regulator will freeze up

 

[JD4440]

Check the carburetor, on mine there is a plug to clean the sump. I have seen the engine start in the morning but not after lunch. Took the plug out and there was a bunch of grease in there interfering with the mixture. Carburetor cleaner will help remove grease. Started up and ran perfectly after cleaning. Good luck!

 

[JD4440]

Check the sump on the carburetor, I have seen the engine run all morning and not start after lunch. There is a plug to remove on the carburetor, there was a smelly grease affecting the mixture. I cleaned it out and it started and ran perfectly. I stuck a wire up there and there was a grease in it. I used some carb cleaner to help clean it out. Good luck!