Glen D Anderson
Member
Good morning,
In the process of reinstalling the PTO output shaft assy. on our 40U...
I have questions about the seal used for the output housing to transmission case connection - Item # 5(M2348T) on the parts break down shown below.
After receiving the parts to rebuild the output shaft assy. & finding that M2348T was a cork seal I decided to go to the local bearing house to find an o-ring to fit this groove. Turns out that the cross section of a 236 o-ring is not quite large enough to provide enough protrusion to seal properly. A metric o-ring may work but is not a stocked item for this store.
So...back to the M2348T cork seal. Can anyone provide any info on how well these seal & any application specific installation instructions? Install with sealant? Soak in oil? etc.
TIA
In the process of reinstalling the PTO output shaft assy. on our 40U...
I have questions about the seal used for the output housing to transmission case connection - Item # 5(M2348T) on the parts break down shown below.
After receiving the parts to rebuild the output shaft assy. & finding that M2348T was a cork seal I decided to go to the local bearing house to find an o-ring to fit this groove. Turns out that the cross section of a 236 o-ring is not quite large enough to provide enough protrusion to seal properly. A metric o-ring may work but is not a stocked item for this store.
So...back to the M2348T cork seal. Can anyone provide any info on how well these seal & any application specific installation instructions? Install with sealant? Soak in oil? etc.
TIA