jim sylvester
Member
Looking for an adjustable front end for a 1941 John Deere M. just need the center tube
M-MAN
Well-known Member
- Location
- Bostic, NC
M's came out in 1947. Check your serial number against the list on the left column for the correct year as there were a few changes. They show up un ebay regularly.
jim sylvester
Member
that was supposed to be 1948
James Howell
Well-known Member
This might be a good source for OEM parts for your <a href="http://www.farmerjohnsparts.com/">Model M</a>.
Hope this helps.
Hope this helps.
bollweevil
Member
I have one, give me a call 256-656-7089. Thanks
M-MAN
Well-known Member
- Location
- Bostic, NC
1947 & 1948 are identical in appearance and 1949 had a slight change in the support wedges but will work fine. Most should have had the pivot shaft update with bushings installed. Those rubber torsion springs didn't last long. BTW - these things aren't very expensive on ebay from most sellers so be carefull. JMO
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy