Just Pickup Allis WD45

[burnsts]

I paid $900 for this, it has factory Wide Front, Original Power Steering, Milwaukee Loader, rear wheel weights and 3 Point.
The tractor runs perfect, doesn't smoke at all, the guy sold it because it had a radiator leak.
When the tractor is running it just sprays from a big hole in the center, I'm hoping to solder it.
Can't wait to get the radiator fixed and go use it.

 

[Coyote Green]

Picture

 

[Coyote Green]

Picture

 

[Coyote Green]

Picture

 

[BushogPapa]

Would you mind if I asked you to send additional pictures of that 3-Point and how it is attached to the Drawbar..??

That IS a nice WD-45...!!

Thank you..

Ron..

 

[Good Dog]

I have been in the hole in the radiator bit many times and have learned that my soldering lacks something. Save yourself a lot of headaches and dollars and take it to a good radiator shop. They will solder any leaks and pressure test it. Probably for less that $100.
Joe

 

[Kip-Utah]

Nice 45. Those are some funky looking wheel weights! Don't think I've seen that type before.

 

[burnsts]

The wheel weights are printed D-17, so i guess they are not original, but they get the job done

 

[Coyote Green]

I have a friend that has a presser tester, he worked at a truck repair shop, he has fixed many of my radiators and they have all held great.

 

[Coyote Green]

Here are some more pictures of the 3point.
I did notice that the bolts holding it on are about to fall out (Oops)

 

[Coyote Green]

Picture

 

[Coyote Green]

Picture

 

[Coyote Green]

Picture

 

[Coyote Green]

Picture

 

[BushogPapa]

Thanks, those explain a lot..!!!

Very well done...

Yep, you found a really NICE WD-45..!!!

Ron.

 

[chevytaHOE5674]

Looks like that 3pt doesn't utilize the tractor booster. But thats ok if your not pulling any mounted ground engaging implements.

Did you happen to get the snap coupler latches for the lift arms with the deal?

 

[BANDITFARMER]

Good lookin WD45 you got a good deal! Like all tractors it just needs alittle TLC here and there. There is one thing I see it needs on the 3pt, It needs the U bracket that bolts to the lift arms so the adjusting link(screws up and down) so the lift arm can swing side to side. Look at the picture of my D17 and you can see what I mean on the lift arms. They are easy to make and do make a diffrence. Bandit

 

[tim(in)]

Where was this tractor when i was looking and had the cash? lol great deal!

 

[chalmersbob(Pa)]

The 3pt arms shouldn't attach to the drawbar carrier. they should attach to the drawbar to have draft control.
Nice looking WD45. That looks like my AC # 40 loader that was on the D14. I just moved it to the D15 this spring. D15 has PS. Bob

 

[Ric Ks,]

WHAT???? No tool/grease gun box. No crank holder bracket. I bet you didnt even get the crank!! And that looks like the wrong seat! Man did you get ripped,, Bring it on over to my place while its still loaded up and I'll give you 800.00 for it so you wont have to feel so bad. Some guys just dont know what to look for and just ask to be taken. But like I say I'll take her off your hands. 8)

 

[burnsts]

sorry i would have taken you up on that deal but i got it unloaded last night, i guess I'm stuck with it