Knot not forming

marvintj

New User
I have an old oliver Model 60 baler that was having the knot come apart when I used nylon twine. Switched to Sisal and the knots started to form nicely and only had 4 knot failures in about 100 bales instead of every other bale being bad. One needle and knotter always works fine. the other needle periodically will have a knot on the needle side of the bale, but the long piece of twine as no knot in it and looks somewhat frayed.
Reading the troubleshooting section of the manual there were about 10 or 15 things that could cause this. When I turn the baler over by hand and watch the knot form and slide off the finger the knot seems fine and not any different than the good knotter. Obviously there is some difference and I am not seeing it. I have had this old worn out baler for about 5 years or more and I am just figuring out how the knotter works. I still do not know the names of all of the parts of the knotter. I did sharpen the knife very sharp as my index finger will tell you this morning. I did make sure that everything was greased. I did blow all of the dust and dirt and grud off of the knotter. I did make sure that the twine clamps at the twine box had close to the same tension. I do not have a scale for measuring holding strength of the twine holder in the knotter.
I do marvel at who ever came up with the knotter concept in the beginning. I know that it has been improved some, but there is certainly a lot going on in a short amount of time and it amazes me. Now to get the one knotter to amaze me a little more.
ANy thoughts on what my problem might be?
 
I have a N.H. but according to N.H. your bill hooks are slightly different for Sisal than Nylon. And they are. I dont know about oliver.
I think all knotters work close to the same and patterned after each other. Do you knife arms that cut and push twine off the billhook travel around a cam, or track. Make sure the bushings are free and not stuck. Also that they are still round and not just dragging on a flat spot. Ive had both of these cause me heck. Simple fix. However I would just use sisal and forget nylon. Esp when you have that much diff. in the way it works. Good luck
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top