LA Front Rims

Hotflashjr

Well-known Member
Location
Western MA
What is the best way to remove the bearing on the inside of the LA front rims? This is the side towards the motor. Should the metal piece that the felt seal sits in be flat or cone shaped that holds the bearing in? Thanks!
 
After just searching JDparts.com I noticed that the retainers, the part I am looking to remove, are still available. If I damage one while removing it my local dealer has one in stock. Also, the felts are still available as well.
 
Hi Hotflashjr..........I've been watching your messages with interest as I just bought a 46 LA with plow that looks of similar original shape to yours, but I spend more than you did. I will be digging into mine soon just like you are! can't wait. my dad machined the heads on the L and LA's starting in the fall of 45 through the late winter of 46 before he started farming, so I was glad to find one in my area. I need to fix one of the main rod bearings as it clunks pretty good. good luck.
 
I'll keep on posting my progress and findings as I go. It doesn't seem that there is as much info on the L/LA's as there is for some of the other models. I just recently bought the Jensales Repair manual and it is a pretty good reference. I wish it had a bit more information than it does, but still better than the SM2000 and operators manual.
 
You usually need new felts and retainers. The retainer is a metal cup with a flange on the outside and a hole on the inside. I usually just drive on the back bearing and knock it and the retainer out together. Be careful you don"t slip off and drive on the edge of the hub and break it. I had that happen once.
 
What I ended up doing was taking a large wood dowel that barely fit through the center of the hub and sliding that into the center of the rim. I wanted to make sure that I didn't harm the bearings while banging on them and I figured that the wood would be soft enough, and wide enough to drive out the parts as evenly as possible. I placed the rim on an empty trash can to support the outer edge of the rim with rags in the bottom to act as a cushin for the parts when they fall through. A few good whacks and the bearing and felt retainer cup fell right out. I had sprayed the cups with PB Blaster for a few days and I think this helped. One of my retainers was concave, not flat, and it ended up ruining the bearing on that side. My local JD dealer had felts and retainers and I think it was about $35. We have a local shop that just deals with bearings. Should I just replace both bearings while I have it apart?
 
Let me know if you need any manuals. I have the cutltivator owners book I could send a copy of as well as the original owners manual, parts book & #7 mower manual and parts book. Check out JDParts.com. There you can find out what parts are still available from JD. If you want to share your e-mail, I can send along a copy of my wishlist from JDparts.com that has a lot of the gaskets, oil seals, & some other parts still available.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top