Learned something

Finally found a picture that explains how these metal hanger brackets work. Im all set now.


cvphoto113992.jpg
 
As long as we're bashing want-to-be carpenters, how about these stairs, the risers are 10,7, and 4 inches! It would of averaged out to a perfect 7 inch! And it's built out of new redwood!
cvphoto113994.jpg
 
Modified Simpson hangers nothing new. When the bookstore roof collapsed years ago the rebuild contractor found all kinds of altered or misused hangers. But that was back in the day when you could get your clear inspection for a burger beer and fries lunch.
 
Well, whoever did it wasn't trying to fool anyone that he is 'hanging' the joist (which continues past (and above) the beam. He's just adding a wee bit of extra support under likely the center area of the joist's length. Well, he thinks he is, it's not really doing much of anything, but it's not hurting anything either. He must have had lots of extra hangers (actually, 90 degree hangers at that) as he could have use some 2x4 blocks to do the same thing. Poor aim on his decking screws or nails.
 
ya i saw he is has cut out way over half way through the plank, even if he nailed a 2x4 under them horizontally would not make it look so beginerish and actually hold a lot more weight.
 
My neighbor has a 90 hp Kubota tractor that is about 18 years old. The bottom two steps are evenly spaced, but the last step into the cab is a bigger distance. I fell into that cab several times until I got used to it.
 
Hard to say for sure Rust Red but I see the photo differently than you do. I think the joists are not cut at all, they just continue intact across (but above) the beam (underneath). I think he has installed blocking between the joists (which make it look like the joist is cut) and then nailed up some of those hangers between the blocking to give a bit more support to the center area of the joists.
 
(quoted from post at 14:32:32 01/14/22) Hard to say for sure Rust Red but I see the photo differently than you do. I think the joists are not cut at all, they just continue intact across (but above) the beam (underneath). I think he has installed blocking between the joists (which make it look like the joist is cut) and then nailed up some of those hangers between the blocking to give a bit more support to the center area of the joists.


I believe you are correct in that the roof joists are whole. You can see the dark gap between the blocking/fillers behind the brackets.

I will go further and say the hangers are upside down because he is using them to support the top of a divider wall to keep the firewood piled up. Firewood crib of sorts, likely another nail vertically up thru toe of hanger into bottom of each joist.
 
Some people have original ideas. When my sister had her barn built here in Tn., neither she nor the carpenter (?) she hired wanted to toe nail the rafters so they laid them flat and nailed through them.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top