I recently built a new bucket for my 641 loader. 2 feet high, 2 feet deep, and 6 1/2 feet wide. I will be using it primarily for snow removal, but, I have a small problem. After welding it all up it looked fine, but after about a week sitting before I could hook it to the loader, the bottom edge has developed a frown. It's about an inch and a half off the ground in the middle.
It was made with 3/16 steel with 1/4 inch cutting edge added. I have tried thinking of a way to straighten it but haven't come up with a workable solution yet.
Any ideas? other than using a maul and swinging all day and denting it all to pieces?
Wish it had gone the other way and made a smile, could fix that rather easily, but the frown has me scratching my head.
It was made with 3/16 steel with 1/4 inch cutting edge added. I have tried thinking of a way to straighten it but haven't come up with a workable solution yet.
Any ideas? other than using a maul and swinging all day and denting it all to pieces?
Wish it had gone the other way and made a smile, could fix that rather easily, but the frown has me scratching my head.