loader cylinders

[Tinks 1996]

I found a set of cylinders for my loader on my Farmall 560. The number on them is 462259R1 . My question is are they dual action ? They did not have hoses on they but are made for o-ring fittings on both ends .Thanks

 

[fastfarmall]

That looks like a IHC number,so its a IHC loader also,can u lift the front end of the ground, if it will i think u got two way cylinders !

 

[Tinks 1996]

I have not hook in up yet. I was just trying to find out before I do. Or is the only way to find out is to try it ?

 

[Jim.ME]

(quoted from post at 17:55:43 07/02/23) I have not hook in up yet. I was just trying to find out before I do. Or is the only way to find out is to try it ?

Post some pictures of the cylinders. The part number you posted does not come up doing a part number search on the CNHi site.

If they are off a loader and they require O-ring Boss (ORB) fittings in the cylinder ports, they are likely double acting cylinders. Not saying some didn't, but I don't know that I have seen a single acting cylinder that used ORB fittings.

 

[fastfarmall]

Well if theres a hyd port on each end, i would action cylinder !

 

[Tinks 1996]

(quoted from post at 15:23:59 07/02/23)

(quoted from post at 17:55:43 07/02/23) I have not hook in up yet. I was just trying to find out before I do. Or is the only way to find out is to try it ?

Post some pictures of the cylinders. The part number you posted does not come up doing a part number search on the CNHi site.

If they are off a loader and they require O-ring Boss (ORB) fittings in the cylinder ports, they are likely double acting cylinders. Not saying some didn't, but I don't know that I have seen a single acting cylinder that used ORB fittings.

I will try to post pictures