loader instalation

[lowline_farmer]

I have a dual 205 loader it came off a ford 6600 I am installing it on a 1976 ford 5000 I need help pluming it I have a small 1/4 inch hose on the control valve I need to know what it is used for do I need it if I need it where do I plum it in at on the tractor or can I just plug it here are some pictures

 

[Bruce(OR)]

It will never work!!
You just need to deliver that 5000 to me!!!!!
I don't have your answer.
How was the old one hooked up??
Good luck!!

 

[David G]

That line is the sense line for a CCLS system on the 6600, not compatible with the 5000.

Hold onto that valve, it is about a grand for one new.

 

[lowline_farmer]

(quoted from post at 18:03:54 11/12/18) It will never work!!
You just need to deliver that 5000 to me!!!!!
I don't have your answer.
How was the old one hooked up??
Good luck!!

I don't know I bought it at an auction sale

 

[David G]

That is not the correct valve, the one you want is a lot lower cost.

I had to buy one like that when I changed my loader over, cost me a grand.

That valve is a CCLS, I think the one you want is an OC.

 

[lowline_farmer]

DO I need to buy a new valve then

 

[Mike(NEOhio)]

OK, what does that mean? Closed Center L? S? I'm not a hydraulic whiz but curious.

 

[J. Schwiebert]

Closed center, load sense. I need to look in my old book and I need the valve casting numbers.

 

[Mike(NEOhio)]

Thanks, John.

 

[lowline_farmer]

this is the only numbers I have on the casting valve so what size spool valve do I need for my ford 5000 only pumps 6 gpm how big of a spool valve do I need