Looking For A Tiller

[edmscutch-HT]

Hello, I have a YM146 with a three point hitch and power takeoff. Did Yanmar make a tiller for this? Is there other tillers that would work on this tractor?
Thanks

 

[techwing-HT]

Not sure about the tiller... I'm still trying to figure out what I need to do to add a 3 point hitch to our YM146.

Could you send me a couple photos?

I have the rear PTO, but no 2 or 3 point hitch. I also don't have the level-controlled arms at the back (although I do have hydraulic level controls for the belly mower). I can find many 3 point hitch "kits", but they don't look like they would have everything I need. But since I don't know what it should look like, I'm a little confused.

Once I get a hitch figured out, I'm interested in locating a tiller. I'm under the impression that any smaller 3 point, PTO driven tiller would work... say a 36-40".

Thanks!
Jason

<ATTACHMENT filename="YM146.jpg" index="0"><s>[attachment=0]</s>YM146.jpg<e>[/attachment]</e></ATTACHMENT>

 

[edmscutch-HT]

Hi Jason,
I will take a couple of pictures of my 3 point and pto for you and post them here. I will also look to see if I can find who I was buying the parts from as well.
Thanks
Eric

 

[edmscutch-HT]

Here ar the pictures of my tractor, the lift works on the hydro with the mower deck. I could'nt find the paperwork when I purchased parts for it, but if I run accross it I will let you know. Hope these help.

 

[techwing-HT]

Thanks for posting the photos! That is helpful.

On the "driver's side", the torque tube for the lifting mechanism has a small arm inside the implement hoisting arm. I believe this is what is connected back to the lift for the mower deck. How is this connected to the decK?

In my photo, there is a slot in about this same area. If I follow the slot back, I can see one end of the lifting cylinder for the mower deck (actually, the mounting bracket for the stationary end of the cylinder). The design of my mounting bracket does not allow the cylinder to be detached from the deck and reattached to the rear lift. Is there some other type of linkage that goes through this slot?

Assuming some other type of linkage, if one end is on the arm of the torque tube for the rear lift, how does the other end connect to the mower deck lifting system?

Thanks again... at least your pictures help me know what all isn't on my tractor!

-- Jason

 

[budlight3b33-HT]

does anyone have pics of how the 3 point attaches to the hydraulics

 

[liuliapril-HT]

I like to make friends with you,haha.


----------------------------------------------------------------------------------------------------------------------------------------
<s>[url=http://www.rchelicoptershops.com/]</s>Rc Helicopter<e></e>[/URL]|<s>[url=http://rc-helicopters-reviews.com/]</s>Rc Helicopters Reviews<e></e>[/URL]