Lubrication for pins

Mtjohnso

Member
I just took apart a couple of linkages that were held together with pins that dont move very much at all.
Some examples of that are throttle linkage and brake linkage on older tractors. After many years these can get rusted into place.
I was able with some effort to get these pins out and cleaned up.
So when I go to reinstall the pins should I put grease on the pins or antiseize or???
What has worked for you?
 
Nothing is 100% foolproof. Leave it long enough and it will rust solid even if you glop on anti-seize or grease.

In reality it's either-or, and anything is better than nothing. Anti-seize is nice because it has a convenient brush in the cap, while you're searching for a rag to apply grease, or to wipe off your finger after applying grease.
 
I use anti-seize in most situations like that and find it works well and lasts a long time. We are in a pretty dry climate here, especially this past year.
 
Squirting some oil on occasionally will do the most for it and will work in as you use it over time and still not rust up if done every so often. Ours set inside and we may oil them once a year or less with no rusting up.
 



Aerosol chain lube is great for pins. which are very similar to chain. It comes out of the can thin and penetrates, then it sets up and lubricates and stays put much longer than oil.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top