Ac145

Member
Hello to all about 25 years ago dad and I went up to this farm and bought the Massey 44. I remember the fella saying that his dad said it was a good pulling tractor Well here we are 20 to 25 years later And I'm just like that fella at that farm we went to that I'm getting ready to sell the old Massey 44. Completely stock as far as I know it's a good runner first gear down the track and placed first second or third depending on how many Allis Chalmers were in the field and a few John's . We had an old guy in the tractor club that was very knowledgeable and into auto electric that was his job
. Well they switch the old Massey over to 12 V. So over the course of last summer I've been putting the old Massey out in front of the house trying to sell it. So I went out to start it and crash boom bang .broke the starter nosecone. Not good ,had it welded back up I have since Switched it back to 6 V . Dad had kept all the old parts so I was able to switch it back to 6 volt . So in needing some help now that it is back to 6 V and running I'm showing discharge on the amp meter. Generator is producing 7 V I've got 7 V at the battery so appears to be charging at this time but the amp meter is showing discharge Any help or suggestions thanks for any help
 
Tractor was 6 volt positive ground system when new. If it was changed to 12 volt and had an alternator installed it would have been changed to negative ground, and the ammeter post wires swapped to make it read right. Swap the post wires again and I'll bet it will be right again if it's been put back to positive ground.
 
How about we slow it down and give a bit more detail to the dieseltechs explanation. This is just in case you do not understand. Say you are looking at the terminal side of the ammeter, you have a left and right post. All the wires on the right terminal need moved to the left one. Visa-versa, all the wires on the left terminal need moved to the right.

Edit: Even I screwed it up. Fixed now.

This post was edited by used red MN on 03/06/2022 at 12:07 am.
 
OK thanks I will try the swap on the terminals that's kind of what I was thinking also but extra added advice sure helps .
And hopefully that'll cure the problem of when I turn the key on and flip the light switch on the amp meter goes to positive side.
 
Is that battery or magneto ignition?

If its mag, nothing needs to be done.

if its battery, the coil polarity may need to be reversed (+ to distributor, - to ign switch). Also remove the resistor or put the 6v coil back on.
 
Well thanks for the members Help all this all I did was yes switch the leads on the ant meter fired right up showing charge while running
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top