Mccormick

[Mccormick WD9]

Looking for front loop ring rim 7.50x18

 

[rustred]

i have a few of them rims. just so u know thats not the only tractor that uses them rims. from the super w6 to the 660 use them rims. also the case 900 uses them , could be more also.

 

[Mccormick WD9]

Thanks for the information. I need to repost in my area of the different tractors that use the same rim..What are you asking for one & where's your location? I'm n/w of Houston Tx.
I've done a couple old Ford tractors years ago, saw this & bought it.

 

[rustred]

Thanks for the information. I need to repost in my area of the different tractors that use the same rim..What are you asking for one & where's your location? I'm n/w of Houston Tx.
I've done a couple old Ford tractors years ago, saw this & bought it.

the shipping cost would not make the rim worthwhile. im in alberta canada.

 

[Mccormick WD9]

the shipping cost would not make the rim worthwhile. im in alberta canada.

Yes I agree

 

[Crazy Horse]

the shipping cost would not make the rim worthwhile. im in alberta canada.

Hi Rusty, hope all is well with you. Up here where you and I both live, you couldn't afford to mail it to the next town by Canada Post or worse yet Fedex or Puroator.

 

[BarnyardEngineering]

If you can find a 6-hole 18" rim, some judicious use of a torch/plasma and angle grinder will turn it into a loop rim. That's what I did for my Dad's W400 several years ago. Cut through the spot welds and the center pops right out.

 

[rustred]

Hi Rusty, hope all is well with you. Up here where you and I both live, you couldn't afford to mail it to the next town by Canada Post or worse yet Fedex or Puroator.

i am doing ok, keeping busy .ya you got that right. you are south of me in which town?

 

[Crazy Horse]

i am doing ok, keeping busy .ya you got that right. you are south of me in which town?

Actually east .... Sherwood Park, just outside of Edmonton.

 

[Mccormick WD9]

If you can find a 6-hole 18" rim, some judicious use of a torch/plasma and angle grinder will turn it into a loop rim. That's what I did for my Dad's W400 several years ago. Cut through the spot welds and the center pops right out.

Thanks for the information, I'll start looking for a 18" rim

 

[rustred]

Actually east .... Sherwood Park, just outside of Edmonton.

Ok, I go past there when I head to camrose on 21. Have to stop for a coffee.