MCV Question

[farmall706]

What is the best way to remove the MCV from the tractor? I have all the bolts out, except for the pump bolts. Is there a way to jack it off with bolts? It must be doweled, and it is tight currently. Any suggestions? Thanks

 

[the tractor vet]

Yep , they stick on real good . Use a stiff bladed putty knife to break the seal of the gskt. DO NOT LOOSE THE LITTLE SPRING on the sump check plug down in the lower right hand corner .

 

[Mark in Upstate]

Hey Vet, which side of the check valve does the spring go, tractor side or MCV side?

 

[the tractor vet]

the check valve goes into the body of the center section and the spring goes against the MCV

 

[Mark in Upstate]

Great Vet, Thanks! I had worked on the MCV and lost the spring - pretty foolish, and didn't realize until she did want to shift properly with the amplifier. I am going to use a ball point pen spring. I was told by my local IH guru that it will work fine. Again Vet thanks. Love to read your posts!