Message to GBinMT

[Tom (Kenton)]

Gary-
Jerry(MT)(from the Ferguson board) told me to contact you to see if you could help me. I broke the venturi around the base of the flange when I was disassembling my TSX 458 carb. I have a Ferguson part number, but apparently the part is discontinued. Do you know of a source for a replacement? Any help you can give me is appreciated. Thanks!

 

[GB in MT.]

(quoted from post at 12:57:57 08/05/10) Gary-
Jerry(MT)(from the Ferguson board) told me to contact you to see if you could help me. I broke the venturi around the base of the flange when I was disassembling my TSX 458 carb. I have a Ferguson part number, but apparently the part is discontinued. Do you know of a source for a replacement? Any help you can give me is appreciated. Thanks!

Tom;
While the carb kits for the TSX 458 are still readily available...the venturi is not , and is not in any kits that I know of. However, If you email me a pic. of that venturi....I may have a used one, (depending if the carb that I was given for parts, is still out in the shack!!!!
Just shoot me an email with the picture and I'll see!!!
"bout' the only way I can help ya, with yer delema!!!
Only other way would be to locate someone with that venturi, that they can part with!!!! :roll:

My email is open at the bottom of this reply....on the modern side of this forum!!! Just poke the button and start sending!!!! :lol:

Gary

 

[Gaspump]

Call just 8N's.

 

[Tom (Kenton)]

Gary-

Just sent you am e-mail with some pictures. Thanks for taking a look.

Tom

 

[GB in MT.]

(quoted from post at 14:30:34 08/05/10) Gary-

Just sent you am e-mail with some pictures. Thanks for taking a look.

Tom

b:f68ab7f943][i:f68ab7f943]

Tom;
As G...P.... told ya...you can buy the plastic venturi from nnalert's BUT....as far as I know the brass ones, like you want have been fazed out, as Jerry has already told you!!!
I'll check out your email....then reply to that!!!

Gary 8) [/i:f68ab7f943][/b:f68ab7f943]