Mf 180 3 point hitch problem

Phil Tibbetts

Well-known Member
I have a MF180 I bought last summer with a bad engine. I now have the engine rebuilt and back in the tractor. My problem is with the 3 pt hitch. It will only lift and lower if I put the Quadrant lever all the way forward into the pressure control section to raise it and lower it. I push it all the way forward and it will lower. If I pull it back about 1 inch it will start to lift at 3 to 4 inches back it is fully raised. I can control the height it lifts this way but I know something is not right. It does have 1 set of remote couplers on it but that seems to be okay. Any suggestions will be appreciated. On another subject I am curious as to why this tractor and my 205 industrial have 2 return fuel lines 1 to the tank and 1 to the filter.
 
Hi,
I'm guessing that you have nothing attached to the 3-pt. In the Pressure Control quadrant hydraulic pressure commences at around 300psi, normally enough to lift the 3-pt only and can be raised to full pressure. Was it working prior to the engine repair? From your description there may be a roller seized or possibly the position control linkage frame worn or bent and it is not allowing correct movement. I would suggest draining the oil to the level of the bottom bolt on the RH side cover and remove it.
You will see the pump control lever moving in response to the quadrant lever positions and relative position of the 3-pt. You may have an 'all or nothing' movement in the position control section suggesting a problem in the lift cover linkage. The remotes should not have any bearing on this problem if they are connected correctly.
As to the returns. The lift pump supplies more fuel than the main pump requires. It is kept full and the excess under light pressure is returned to the filter or remains stationary until fuel is consumed. The tank return takes the excess fuel supplied to the injectors back to the tank normally via the small reservoir mounted at the front of the tank which provides fuel for the thermostart starting device if you have one fitted. They are fitted to all UK and most European tractors but not to all in North America.
DavidP
 
I don't know if it was working or not when I bought it as it was not running. I do know it had been sitting outside for a few years and water got into the engine cylinders and stuck them. I will have to check out the linkage this spring. As for the return lines I realize the purpose for them buy was just wondering why they have 2. Thanks for the info.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top