(800) 853-2651
SHOP NOW

MF Special Tools

Yesterday's Tractor Forums
R

rust-o

Member
Hi all,

I am in the process of adjusting the hydraulic lift cover on a 165
The book says I need MFN 124, MFN 163 and MFN 970 Tools. From searching in the archives I have found ways to substitute for the tools.
MFN 124 = 11/64 feeler gauge ( .17")
MFN 163 = 3/8" thick piece of flat steel
MFN 970 = anything that will hold the dash pot plunger fully extended.

Do these substitutes seem adequate. Any suggestions/improvements?

thanks
 
You must log in or register to reply here.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top