MF65 LED lights

nisse

Member
I am adding 4 15 watt led lights to my
MF65. The original lights/wiring was
toast and rigged together so I ripped it
all out. I am wondering what is the best
way to run my power. My plan was to run
from the battery through a fuse then a
toggle switch out to the lights. Any
reason not to do it this way? What is a
good way to go from one wire off the
switch to the 4 wires for lights?
Thanks,
John
 
Add up the total amperage draw of the lights, LED and the old ones if they are going to be left working. Be sure the switch is rated for the amperage load of all them. DC current has a nasty habit of welding contacts together if a switch is not rated heavy enough for the load applied. I like the idea of using a relay to control the lights. That way the switch doesn't carry so much load and therefore can be a lesser rating, just enough to turn on the relay so that can also be a smaller wire gauge. A junction block installed after the switch is a neat way to connect multiple wire to the lights. A fuse in the line feeding the switch is also good.
Gene Davis Tennille, Ga.
 
Instead of coming directly off the battery, pick up the power at the starter solenoid, or the amp meter. Connecting directly to the battery puts the small wire too close to the corrosive conditions of the battery.

The load will only be 5 amps, so about any switch will do. If this is an open cab, it will need to be weather and dust resistant, think a marine switch with a rubber boot.

Fuse the circuit to the wire size. 14 gauge is good for 15 amps. Solder and shrink tube all connections. Use fine stranded, low voltage automotive wire, not solid or THHN building wire. Secure everything away from snags, pinch points, and heat. Use metal straps, they are more permanent than plastic or zip ties. Hiding the wire in split plastic harness loom gives a professional look and protects the wire..
 
Thanks for all the replies, picked up some supplies, hopefully will get it done before the next snow storm on Monday.
John
 
If you have an ammeter and you want it to show charge condition of your electrical system when the lights are on you need to power them from the generator/alternator terminal of the ammeter, just as the other system loads should be powered from. Going direct to the battery or solenoid stud bypasses the ammeter.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top