I was using this saw to limb a downed oak for firewood. Fully charged 12ah batt. I used it off/on for about 1 hour. Took a break. Grab saw, push safety button, pull trigger, ran for a second then stopped. Pull trigger again, same. Pull a 3rd time, off it ran. Put it down to move limbs. It does not run. Batt = full charge. Grabbed a fully charged 8ah batt. Still does not work.
There were no chips, dust, in either batt nor in the saws battery connection.
Batt connection looks clean, no tarnish.
Loosened chain, removed side cover, cleaned out nothing but dust. Put it back together. No change.
Any ideas?
Thanks much...Don.
There were no chips, dust, in either batt nor in the saws battery connection.
Batt connection looks clean, no tarnish.
Loosened chain, removed side cover, cleaned out nothing but dust. Put it back together. No change.
Any ideas?
Thanks much...Don.