More spark plugs

SVcummins

Well-known Member
I picked these up today had the r44 already the r45 should be hotter .
cvphoto66178.jpg


cvphoto66179.jpg
 
SV I’m no help on your plugs. Have an L10 that seized up while plowing snow. Haven’t pulled the pan yet everything was loose on top. Guess we will find out tomorrow.
cvphoto66188.jpg


cvphoto66189.jpg


cvphoto66190.jpg


cvphoto66191.jpg


cvphoto66192.jpg
 
that is correct, they are a longer reach. i was looking through my tool box couple days ago and found a set of these used ones. been there since 1982 or 83 since i worked in GM garage. so i guess they are antique now. lol.
cvphoto66193.jpg
 
Has it ever been apart? The bearings in mine fell apart. Literally. Local expert told me they had trouble with British bearings. Sure enough, when I took it apart, bearings were made over there. I can't remember exactly what was stamped in the bearings. England, Great Britain? Expert said he had never seen bearings that bad come out of an engine still running. I was getting pieces when changing the oil!
 
Bob I don’t know if it’s ever been apart. Engine is out of early 90’s IH. Thinking main bearings may find out tomorrow.
 
Mine is a 1990 IH. Run hard and abused by a prior owner. Head gasket blew. Sent head out. Shop said they had never seen so many cracks in a head! It's got that goofy low flow cooling system. It heats up fast!
 
Ok that’s what I wanted to here . Since I went to the 2050
engine oil my oil consumption dropped buy 2/3rds metric guys
your are on your own
 
Better put a pan heater on it for your winter temps. 20w50 can twist an oil pump driveshaft off on a small block Chevy with just the starter.
 
Yes, they will work fine. Notice the tip extends into the combustion chamber not the thread. I always use the Autolite platinum tip.
 
Hotter plugs are for low rpm running (a lot of idle ing ) , cold plugs are for high rpm racing engines.
Not much works for oil fouling other than fix the problem .
I ve seem Ford three six have problems on center 3and 4 with heat range s , Also the big 454 marine , they idle out River to lake at 5 miles per and load up , but once in lake and running full throttle goes away , but cost of fuel most don’t do that and they are always loading up ,no cure for it l.
 
yes, under the wrong conditions. in your case its a run around truck and dont spend a lot of time at operating temp. its ok . if using them at high temp prolonged running they can cause preignition.
 
I’ve been wanting to put a block heater on it but it doesn’t need to run when it’s that cold anyway
 
With the amount of miles I put on it will be another five years before I need to worry about plugs again
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top