Adirondack case guy
Well-known Member
I pulled a Frank Sanatra and did it "my way". Flange on bottom, but at this point I can rotate the chassis 360, so no overhead welding.
Next question--- I welded it in the RH side veiwing it from rear. Is that right !!!!.
Just busting all you guys, HeHe.
Here are some pics of the chassis from today.
The body is 10' long and the pole of the chassis is 10' long and set 3' forward of the back of dump body and the rear hinge point of the body is at the rear, so I don't loose any dump heidth when dumping, thus the extension welded to the rear of the axle.I'm not finished with the rear extension. The square tube seting on frame will be cut to length and welded in to extend the pole back to the rear and I will add some diaginal braceing .
Bro in Wyoming promised me some warm weather in a couple of days, so I can get some paint on the chassis, but local weather watchers are predicting cold weather with acumilating snow tomarrow. Hope he comes thru.
Loren
Next question--- I welded it in the RH side veiwing it from rear. Is that right !!!!.
Just busting all you guys, HeHe.
Here are some pics of the chassis from today.
The body is 10' long and the pole of the chassis is 10' long and set 3' forward of the back of dump body and the rear hinge point of the body is at the rear, so I don't loose any dump heidth when dumping, thus the extension welded to the rear of the axle.I'm not finished with the rear extension. The square tube seting on frame will be cut to length and welded in to extend the pole back to the rear and I will add some diaginal braceing .
Bro in Wyoming promised me some warm weather in a couple of days, so I can get some paint on the chassis, but local weather watchers are predicting cold weather with acumilating snow tomarrow. Hope he comes thru.
Loren