Must be Monday!

kcm.MN

Well-known Member
Location
NW Minnesota
Puzzle: https://jigex.com/NP21

mvphoto68903.jpg
 
I watched the snowplough/sander go by my place
one morning. The truck had to stop at the stop sign
at the end of the road for pin coming traffic. The
road was slick with ice, and there is a slight incline
at the corner. Truck stopped ok, but then started
sliding backwards, picking up a bit of speed, then
the crown of the road took the truck to the ditch.
Ditch was about 6 feet deep and upset the truck. I
think if the truck could have just kept rolling around
the corner if there hadn’t been a car coming he’d
been ok, but no, had to stop.
 
I would have thought that if he was putting sand down like he was supposed to that it shouldn't have happened?
 
Not that unusual a sight around here.
Belly mount sanders are better for our
hills. Rear mounts they sometimes back
down the hills when it is icy so the sand
gets under their tires.
 
(quoted from post at 04:47:09 01/25/21) I would have thought that if he was putting sand down like he was supposed to that it shouldn't have happened?


In hind sight it is obvious that he should have been sanding, but generalay the drivers are doing as their boss tells them.
 
Could be he tried to get over to clear the shoulder of the road
and either got over too far or the shoulder gave way. I have
seen that happen a couple times just down the road from me,
although the truck didn’t go all the way onto it’s side.
 
In my college years I use to plow and salt the LI Expressway, we had 10 wheel dumps with a tailgate spreader on the back--it hooked over the tailgate and the salt flowed thru the little shoot in the middle--so you had to raise the body to get the salt to flow--a little too high and all the salt would break loose and flip the body all the way up only way to get it down was to pick up speed and slowly apply the brakes to get the body down---and then with all the overpasses that was a problem too
 
Perhaps a couple of things happening that sand behind him at that time would not have helped.

1. A bit too cold.
2. Sand went down seconds before, sand has not had time to get embedded.
3. His drives are not on top of any sand.
4. He is at the stop, all wheels locked.
5. Once he slides backwards with wheels locked, sand just gets pushed.
 
My brother used to work for s small city and plow snow. In his snow career he turned a dump truck on it's side and flipped a pick
up upside down. The morning the he flipped upside down it was very icy 4 of the plow crew had accidents. Mark.
 
The passenger mirror is still intact so there probably is no damage. A week ago I saw a state plow truck backed into the ditch cockeyed. I don't know if he switched ends on the ice and went in backwards or if he got too close to the ditch backing up. He was sitting there with a tow rope strung out from his front bumper. It looked like whatever was trying to pull him out couldn't get the job done so they went away for something with more pull to get the job done.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top