NAA exhaust and front wheel hub question

[hje2]

I'm restoring my NAA and I have two questions for now. Should the front wheel hubs get grease packed inside hubs? Also, I'm installing a new exhaust and although the Ford master parts catalog indicates that the two piece exhaust is supported to the tractor in the middle, I can't figure out how that's done. Any thoughts? Any pictures?

Thanks,
Harvey

 

[sotxbill]

bearings should be packed.

 

[Hdonly]

I work my Jubilee alot. I got tired of smashing exhaust pipe onder the tractor on tree limbs and such. Took my hacksaw to it.

 

[petertay]

The question was probably about an exhaust underneath, not upright. On our NAA the 2-piece exhaust has a bracket that attaches to the
running board.

 

[hje2]

Thank you, never thought of that, I'll give that a try.

 

[Kirk-NJ]

Yep pack bearing. 2 piece clamp bracket part number 5274 &
55806-S. Connected to bolt on bellhousing. If not a show piece
you can make do with muffler clamp and L bracket from
hardware store

 

[hje2]

OK, thank you. I took this tractor apart 13 years ago and didn't take near enough pictures. Thanks again.