nca99180b replace washer

[itmeagain]

looking for a thicker washer for 850 carburetor fuel line the washer part nca99180b the old one leak bad and i don't want to pay the new Holland tractor company$9.00 for each one them just want to stop the leak it can i take two of them it go between the carb and filter on a tube or can i double up washer to stop it from leaking fuel out

 

[Sean in PA]

I haven't worked on the fuel system for those pre-1965 models in a long time, but since the parts site refers to that part number as a "gasket" I am thinking that it is a crush washer, and if that's what it is, then stacking two regular washers won't do anything to stop a leak there. Perhaps a thick fiber washer that's impervious to gasoline might work. Also, according to the parts drawing, there are two of them, one on either side of the sediment bowl, one between the bowl and the bolt head and the other between the bowl and the carb.

This post was edited by Sean in PA on 03/20/2023 at 05:52 pm.

 

[mhb@ufe]

There much less from this site if they will mail them in an envelope shipping wouldn't be more than the gaskets.

Mark
NCA99180B

 

[WayneIA]

Roll an oring onto the bolt and the washer will pinch the oring to the banjo fitting. Don't overtighten! BTDT, Several times

 

[used red MN]

I knew YTs shipping seemed expensive on many things so I thought I would give a look. They are surpassing the CNHI price with the cost they show for shipping an online purchase, $14.99. I wonder if you sent them a SASE if they could reduce that a bit?