Need Help! Case 1070 will not move.

[Micah2]

We've got a case 1070 powershift that quite moving. It was running a batwing mower and got backed up with the PTO running and something in the transmission made noise, clunking/banging. It started having shifting issues and then the powershift wouldn't do anything and then the tractor would barely jump a little letting the clutch pedal out. Now the tractor Runs but will not move at all, nothing I do to the transmission makes the noise of the tractor running change at all. Hydraulics are still strong. I was not the one running it when it quit so all that info may not be 100% right. Any help is greatly appreciated!!!

 

[Micah2]

The transmission fluid is good.

 

[StanIowa]

It could be the torque limiter. The torque limiter is bolted to flywheel. It will have to be split to be replaced. If the hub broke free of the disc that would be the noise that was heard. Stan

 

[Micah2]

But it went about another 1500 feet after that. Would that not be a dead stop?

 

[Micah2]

On the other hand it seems like something pretty early on must have failed for it to not change noise wise at all so that kinda makes sense.

 

[big orange]

Sounds like torque limiter failure.

 

[Micah2]

Well the torque limiter failed. Do you all think the pressure plate and bellville spring need to be replaced? It doesn't show signs of having slipped.
Thank you @StanIowa and @big orange for the help!

 

[Micah2]

Pictures!