need help on 49 A !!!!!

PB in IN

New User
Dad and i are working on our first john deere the last few have been red but we decided to give a green one a try. It is a 49 A we are trying to get it started before we go to far with it. IT was sitting in a garage for the last few years and is in decent shape everything is good mag is hot got good spark carb is good checked it all out. When we try to start it it sound like it is out of time at least i think Like i said this is our first one and were kind of learning on it. Have the books on it too. Any help would be really appreciated thanks a million.
 
There should be an indicator on the flywheel for TDC, make sure the flywheel side plug fires when the flywheel crosses the TDC mark, if so then the start timing is right.
I have found it is much easier to pull start them the first time. I got a 47 and 48 A.
Have yall checked compression yet?
 
A fresh set of sparkplugs often works wonders for an engine that has not been used for a while. You might also want to see that the points are nice and clean -- and gapped somewhere around 0.015". As for tinkering with the timing, I'd say that if it was running anywhere near normal when parked, there is little chance that mechanical timing has been altered.

I am curious on how you can say the carb is good - checked out if the tractor isn't running!!!!! Have you found a new way??? I am anxious to know.

I think a short trip (for you) to the URL below is in order insofar as the carb is concerned. Once there, scan across to ARTICLES 1. From the drop-downs, select CARBURETORS. It is a great read. Then on page 9 you will find a procedure for testing both the IDLE and LOAD sides of the carburetor. If both these tests pass, THEN you can come on here and say the carburetor checks out -- not before! (PatB)
Restoration Site, JD H Tractors
 
Start out with mag on dead center. Got my 49 A at a sale and a brain trust had turned the mag all the way to right. Course no start. I bid and won not known the problem until a while later. Carb was not pure. So.... Now it runs, but will not move or will the pto work. Any quick fixes???
 
thanks bob and alabama did that and they had the plug wires turned around. Switched them around and it fired the first time and ran. Guess thats not to bad for sitting in a garage for four years or so. It has great compression. Guess though i should have been more specific on saying the carb is good as it was cleaned and rebuilt before we put it on so i guess that means it is not good by some.
 
PB -- When it comes to carburetors and the people who claim to have rebuilt them, you can bet that saying you had it cleaned and rebuilt doesn't mean it is good! And this is not just by me, but by a boatload of folks who follow the posts on this board!

Go back and read your initial post. You sounded like a desperate man, ready and willing to tear into re-timing the tractor. You will soon learn that a carburetor is deemed to be good on a John Deere tractor when it does its job well on a running tractor. And even some who have a little “green time” under their belts will claim their carbs are “good” only to learn later that they were careless and over-looked a basic item.

So -- be careful. Don’t come back and bite the hands that feed you. For if you do, offers of help will dry up quicker than a fire hydrant in the West Texas Sun! (PatB)
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top