Need help removing axel bearings

[Steve (NC)]

I am trying to install a new rear axel into a Jubilee. Any advice on removing the bearing sleeve without damaging it? Is it possible?
Thanks,
Steve in NC

 

[Dan]

If you are talking about the race inside the bearing retainer - just knock it out using the two slots from the backside. If you are talking about the bearing attached to the axle - use a pice of 2" PVC pipe and whack it off. If you use a 4' long piece, you can use it to install on the new axle as well.

Dan

 

[Steve (NC)]

Got it off. Thanks for the reply. Just took a little muscle and a hamer with a cold chisel. New axel installed.
-Steve