No spark question

Eng8ball

New User
I was working on getting a JD model M started after 5 years of sitting in a shed. While cranking and checking for a spark from the coil I got nothing, The points were new and adjusted correctly.
The only way I could get spark from the coil was to put a bit of dielectric grease on the contacts of the points. Does anyone know know of an underlying cause that would not allow the points to make contact? The battery is new and fully charged, Thanks, Glenn
 
I've had new points that would not make contact. Just a simple electric switch. If they get oxidized, they get high resistance. Just check
with $3 ohm-meter. I have had to take a file to them many times. Especially first start in the Spring.
 
As JDM said,I have to do my M also when it sets over the winter and new points always seem to have a film on them,fold a piece of fine sand paper in half and drag
it through the points,should solve the problem.
 
(quoted from post at 13:46:57 05/08/19) As JDM said,I have to do my M also when it sets over the winter and new points always seem to have a film on them,fold a piece of fine sand paper in half and drag
it through the points,should solve the problem.

A dollar bill will do the same thing and not wear the contacts, I have to do that on my 8N time to time.
 
Just wondering the other day how everything is going with you, not seen any posts
for some time, hope all is well in the Michigan, young boy must becoming a man by now. did you end up completely out of the Adirondacks.
 
A lot of new point will have a protective coating on them that needs to be cleaned off. I use the flap form the box the point come in to clean them. That said a good brand of points will work right out of the box a cheap set tend to do as your are doing
 
It doesn't take much gray oxide or a thin oil film or any preservative coatings (like on a new set of points) to disable proper points operation. Check and give them a good light cleaning followed by a good drying then try again. Dielectric grease is an insulating material and not for points but in the process of even fooling with the points you have somehow gotten them to function.

If you need more help troubleshooting the cause for no fire let me know.

John T
 

Years ago we never had this issue with new points now we do... I am not gonna fall for it has a protective coating that's BS...Its more they have set on the shelf for 10 plus years and oxidized..
 
Could be the lack of a good ground. There may be a short in the wiring or even defective points. If you are using a coil resister it might be bad. The cap or rotor might be bad. You pretty much have to expect everything.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top