not a tractor but...

ESVADuke

Member
Just picked up a 1926, 1.5 hp John Deere E to run a Burch's two hole corn sheller for popcorn. Looks like a sweet little engine, spins free, fair amount of original paint, most of the parts are there. previous owner of the corn sheller retrofitted an electric motor to it, I think this will be more appropriate, and fun.

Anyone on here every fool with these?
(what am I getting into!)

mvphoto76968.jpg
 
They are a bit tricky to get the low-tension mag and igniter set up properly, and need a functioning foot valve on the fuel line.

Typical hit and miss engine stuff.

NICE engine, BTW!
 
In the process of putting a Fairbanks Morse 3HP back together.

New at this too, so learning as I go.

It has main bearing problems, looks like cast babbet that is NLA, and I don't want to get into (or pay for) trying to cast or machine one. I made a steel shell to adapt it to a soft bronze sleeve bearing. Still in process, will see how it works.
 
(quoted from post at 10:16:48 06/15/21) In the process of putting a Fairbanks Morse 3HP back together.

New at this too, so learning as I go.

It has main bearing problems, looks like cast babbet that is NLA, and I don't want to get into (or pay for) trying to cast or machine one. I made a steel shell to adapt it to a soft bronze sleeve bearing. Still in process, will see how it works.

I've never messed with these old engines, but my brother has an old Hercules. He was saying if the bearings don't have the right alloy mix, and especially if too soft, it will bind up and may ruin the engine, be careful!
 
I have my Grandfather's Model E 1 1/2 engine. I worked it over in High School
shop in mid 60's. I need to dig it out and get it running again.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top